Cooper-instruments-systems Model 5i Advanced Force/Torque Indicator Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Měřící nástroje Cooper-instruments-systems Model 5i Advanced Force/Torque Indicator. Cooper Instruments & Systems Model 5i Advanced Force/Torque Indicator User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 35
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
Model 5i
DIGITAL FORCE / TORQUE INDICATOR
User’s Guide
Zobrazit stránku 0
1 2 3 4 5 6 ... 34 35

Shrnutí obsahu

Strany 1

Model 5i DIGITAL FORCE / TORQUE INDICATOR User’s Guide

Strany 2 - TABLE OF CONTENTS

Model 5i Digital Force / Torque Indicator User’s Guide 9data output, depending on setup. UNITS Toggles between measurement units. DIRECTIONT

Strany 3 - 1 OVERVIEW

Model 5i Digital Force / Torque Indicator User’s Guide 105.4 Average Mode (AVG) Average mode is used to obtain an average load reading over

Strany 4

Model 5i Digital Force / Torque Indicator User’s Guide 11reading with a normally open contact (high to low transition of the trigger signal)

Strany 5 - 2 POWER

Model 5i Digital Force / Torque Indicator User’s Guide 12 Two filters are available: Current Reading – Applies to the peak capture rate of

Strany 6 - 3 MECHANICAL SETUP

Model 5i Digital Force / Torque Indicator User’s Guide 13When set points are enabled, the following indicators are shown to the left of the

Strany 7

Model 5i Digital Force / Torque Indicator User’s Guide 14 Press ENTER to delete the value. To exit Delete mode, press DELETE again. Any nu

Strany 8 - 4 HOME SCREEN AND CONTROLS

Model 5i Digital Force / Torque Indicator User’s Guide 151. Insert the Resource CD supplied with the indicator into the CD/DVD drive in the

Strany 9

Model 5i Digital Force / Torque Indicator User’s Guide 16Non-Windows 7 Operating Systems – When the Mark-10 USB device has been plugged into

Strany 10 - Caution!

Model 5i Digital Force / Torque Indicator User’s Guide 17 Click “Continue Anyway”. 8. The next, and final, screen appears as follows: C

Strany 11

Model 5i Digital Force / Torque Indicator User’s Guide 189.3 Automatic Output The indicator has the ability to output data continuously and

Strany 12 - 6 DIGITAL FILTERS

Model 5i Digital Force / Torque Indicator User’s Guide 1Thank you… Thank you for purchasing a Mark-10 Model 5i digital force / torque indi

Strany 13 - 7 SET POINTS

Model 5i Digital Force / Torque Indicator User’s Guide 19 Selection Function when pressing DATA RS232/USB Output Outputs data via the ser

Strany 14

Model 5i Digital Force / Torque Indicator User’s Guide 20 Units (available units depend on the sensor used) LB Switch unit to pound-f

Strany 15 - 9 COMMUNICATIONS

Model 5i Digital Force / Torque Indicator User’s Guide 21 NPOL Mitutoyo output without polarity (absolute value) PM Print/send data t

Strany 16

Model 5i Digital Force / Torque Indicator User’s Guide 22cells should be used, along with appropriate mounting brackets and fixtures. Cautio

Strany 17

Model 5i Digital Force / Torque Indicator User’s Guide 23 If failed: 5. The following screen appears after the off

Strany 18

Model 5i Digital Force / Torque Indicator User’s Guide 24 Remove the load applied in Step 8, leave the fixtures in place, then pre

Strany 19

Model 5i Digital Force / Torque Indicator User’s Guide 25 Displayed at the start of calibration if a disallowed unit is selected.

Strany 20

Model 5i Digital Force / Torque Indicator User’s Guide 2611 PASSWORDS Two separate passwords may be set to control access to the Calibrat

Strany 21

Model 5i Digital Force / Torque Indicator User’s Guide 27 Use the UP and DOWN keys to select the correct password, then press ENTER to conti

Strany 22 - 10 CALIBRATION

Model 5i Digital Force / Torque Indicator User’s Guide 28 Select Off for the backlight to be off upon powering on the indicator. Select On

Strany 23

Model 5i Digital Force / Torque Indicator User’s Guide 21 OVERVIEW 1.1 List of included items Qty. Part No. Description 1 12-1049 Car

Strany 24

Model 5i Digital Force / Torque Indicator User’s Guide 29This section is used to configure the initial settings upon powering on the indicat

Strany 25

Model 5i Digital Force / Torque Indicator User’s Guide 3013 SPECIFICATIONS 13.1 General Accuracy: ±0.1% of full scale ±1 digit + sens

Strany 26

Model 5i Digital Force / Torque Indicator User’s Guide 3113.2 Factory Settings Parameter Setting Set points Upper Disabled (defaults

Strany 27 - 11 PASSWORDS

Model 5i Digital Force / Torque Indicator User’s Guide 3213.3 Dimensions IN [MM]

Strany 28 - 12 OTHER SETTINGS

Model 5i Digital Force / Torque Indicator User’s Guide 33NOTES:

Strany 29

Model 5i Digital Force / Torque Indicator User’s Guide 34 Mark-10 Corporati

Strany 30

Model 5i Digital Force / Torque Indicator User’s Guide 3Example 1 Model MR01-100 sensor with Model M5i Indicator MR01-100 ±0.15% of full sc

Strany 31 - 13 SPECIFICATIONS

Model 5i Digital Force / Torque Indicator User’s Guide 4testing, especially in aforementioned hazardous cases. Extra bodily protection shoul

Strany 32

Model 5i Digital Force / Torque Indicator User’s Guide 5The indicator can be configured to automatically power off following a period of ina

Strany 33

Model 5i Digital Force / Torque Indicator User’s Guide 6 3.3 Mounting to a

Strany 34

Model 5i Digital Force / Torque Indicator User’s Guide 74 HOME SCREEN AND CONTROLS 4.1 Home Screen No. Name Description 1 Meas

Strany 35 - 0911 REV 1

Model 5i Digital Force / Torque Indicator User’s Guide 8Torque units: lbFft – Pound-foot lbFin – Pound-inch ozFin –

Komentáře k této Příručce

Žádné komentáře