Cooper-instruments-systems DFI INFINITY B Ultra High Performance Digital Forc Uživatelský manuál stáhnout pdf (Strana 36)

4.12.3 Device Setting and Configuration

Device setup requires:

• Entering the IP

address for iServer device (for example 192.168.1.200).

• Specifying Socket number (1000 or 2000 depending on iServer settings).

• Defining RS485 Unit #

interface address (1 to 199). Enter "0" for RS232 interface

or for iServer.

• Entering Reading command. Normally set to X01 to obtain reading from the devices.

If you want to change this setting, refer to HTTPget Section 4.10.

• Defining the Alarm setup

(High/Low, High value, or Low value).

• Specifying Pause Interval. It determines how many seconds each subsequential alarm

notification will be sent.

• Determining Monitor interval

. It establishes the interval or time resolution in seconds

for which readings will be obtained from the device.

Figure 4.25 iServer Mail Notifier Device Setting

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 44 45

Žádné komentáře

Cooper-instruments-systems DFI INFINITY B Ultra High Performance Digital Forc Uživatelský manuál Strana 36